Sealing seams and gaps in the bathroomOctober 4, 2018
It is possible to protect the bathroom from the appearance of mold, despite the very difficult operating conditions here. But for this purpose it is not enough to use only moisture-proof facing materials. An important task is to ensure the sealing of the seams. And after such an event, the joints and joints of plumbing with other surfaces should also look aesthetically pleasing. How to achieve exactly this effect?
What to use for sealing
There are many types of sealing compounds suitable for the bathroom. The most commonly used acrylic or silicone sealant from https://fenixcentr.dp.ua/. They are sold in tubes, which can be additionally supplied with a distributor. If there is no distributor on the container with the purchased material, it will be necessary to purchase a mounting gun.
In addition to the sealant, you need a sealing cord. It is better to buy products of self-adhesive type, then no additional adhesive composition will be needed, and the process of laying the cord will be extremely simple.
How to prepare the site for sealing
An important task at the preparatory stage is to degrease the work area. First, the joint or gap is well cleaned of dirt. This can be done, for example, with a metal spatula. It is important to clean the dirt to the full depth of the gap. Next, go to degreasing, using a solvent or, as the most budget option, soda solution. If the area remains contaminated and greasy, the sealant on it will not fix.
How to apply sealant to the seams
Fill the joint or gap with sealant without breaks. Therefore, a strip of sealing compound must be squeezed out until the entire seam is filled. It is necessary to ensure that the sealant covers the gaps not only along the entire length, but also over the entire depth.
Squeezing a sufficient amount of sealant, it must be smoothed. For this, it is not necessary to use a special tool. You can simply moisten a finger with water, and then hold the treated seam. At the same time, it is necessary to eliminate the surplus, since the sealant should not protrude above the seam.
How to apply a sealing cord
Cord impose over the sealed seam. On the reverse side of the cord, the protective film is removed, then it is applied to the gap, well smoothed and pressed.The cord is needed not only for better sealing, but also to create a good aesthetic effect.
Having completed these activities, the owner can operate the bathroom without restrictions. Now the risk of fungus will be even lower than before.