How to install poles for fence?
Installation of poles for fence is the mostan important stage in the construction of this entire enclosing structure. It depends on the quality of the installation of the poles, how long the fence can remain in its original state. In order for your fence to stand as new for many years, we recommend taking into consideration tips on how to exhibit fence poles, what materials and tools are needed for this.
Material for poles
The main materials of the fence posts are:
- metal profile (round or rectangular);
- square pine beams;
- reinforced concrete.
From tools for work we will need:
- bayonet and shovel spades or a drill for the development of pits;
- cord for setting the posts exactly one line;
- tape measure for intervals;
- level of construction for setting the vertical of the post;
How and what to make poles for a fence
Metal poles are very easy to install,they are durable and durable, but for this they must be covered with anti-corrosive compounds and regularly painted. Posts of wood are environmentally friendly, are relatively inexpensive, and also look very aesthetically in virtually any fence. However, they also require the treatment of special varnishes or paints to protect against the effects of the environment and insects.
The only material that does not requireA special coating is reinforced concrete. The pillars of reinforced concrete remain very, very long, they have a smooth and beautiful surface, and if desired they can be made by yourself.
Installation of fence posts
At the very beginning of work it is necessary to mark the cornerssite, which will be enclosed by a fence. At the installation site of the corner pillar, you need to hammer a peg. After that, the question arises: how to put the poles for the fence perfectly exactly along one line. In this case, very well helps the cord stretched between the pegs.
Interval between the posts of a not very high fenceusually take 2-2.5 m. But if the section from corner to corner is short, then it is better to choose such an interval that will divide the entire length into equal spans. After all the pegs are installed on the posts of the pillars, you can start the land work.
How to dig a poles for a fence
To dig in the pillars, you can use a shovel,but rather a drill. The diameter of the pit should allow the installation of a pole with a 10-15 cm gap between the pole and the wall of the pit. Depth of development should be not less than 0,5-0,6 meters.
At the bottom of the finished pit it is necessary to lay crushed stoneor throwing rocks. Then we set the pillar and fill the free space with stones, leaving room for concrete mortar or earth. Fill the concrete or fall asleep.
In the case of concrete, the post may be pinchedthe solution filled the whole space. The earth needs to be dumped. It is very important at the very beginning to set the post exactly on the level, for after the hardening of concrete deviations from the vertical will not be corrected.
How to Concrete Fence Posts
If the fence is sufficiently high - from 1.5 m - and inHe has a gate or wicket, then the pillars for it must necessarily be concreted. A concrete solution for this can be prepared from a mixture of PGS (PGS) and 300-400 cement in a ratio of 3/1. Water is needed in such a quantity that the consistency of the solution is sufficiently fluid, but not liquid.